CAMI Research Inc. announces another new board for its CableEye cable and harness testing systems. Populated with solder pads to accept both aligned and staggered, 1.25 and 1.5-mm pitch, surface mount and through hole (TH) connectors, the board addresses any market with a demand for board-to-board connections. Rated to 700 Vdc/500 Vac, the CB51 may be used on all CableEye models.
CAMI offers the CableEye suite of low and high voltage products complete with accessories including connector boards. The selection of boards is constantly growing and is currently numbering over 60 – most of which are populated with ‘families’ of connectors. These connectors are shown graphically correct with CableEye’s standard dynamic user interface.
The CB51, sold without connectors, contains four sets of 60 solder pads accommodating numerous configurations of surface mount and TH connectors – aligned or staggered pins at 1.25 and 1.5 mm pitch. There are four preset locations for automatic detection and display of any-pin-count connector up to 60 pins. Yet, any single set may be fitted with any combination of lower pin count connectors that total to 60 or less (e.g. a 40-pin with a 10-pin). Connectors soldered in non-preset positions will also appear graphically correct once they are mapped with PinMap (optional software).
Sold as a set of two boards, each test board may be paired with other CableEye adapter boards to accommodate any combination of connectors.
Customers requiring this board typically have products that may need HiPot testing and that have board-to-board connections such as box builds or other contained devices e.g. AV Equipment & Telecom products.
CAMI Research
www.camiresearch.com
Leave a Reply
You must be logged in to post a comment.