• Skip to primary navigation
  • Skip to main content
  • Skip to primary sidebar
  • Skip to footer

Connector Tips

Connector Tips has connector and electrical connector news, product highlights and and editorial coverage.

  • Industry News
  • Products
  • Basics
  • Electronics
    • Electronics
  • Markets
    • Aerospace
    • Automation
    • Electrical & Instrumentation
    • Medical
    • Military
    • Off-Highway
    • Oil/Gas
    • Telecom/Data
  • Suppliers
  • Newsletter Subscription
  • Video

ERNI USA delivers fully assembled and tested military backplanes

March 15, 2017 By Mary Gannon Leave a Comment

ERNI-Military-backplane-PR-imageERNI USA provides manufacturing and support services for military OEMs with special product requirements, performance specifications, test parameters and supply chain needs. With expertise in press-fit technology (semi- and fully-automatic), ERNI specializes in fully assembled and fully-tested military backplanes. ERNI manufactures high-quality, low-to-mid volume, high-mix military backplanes for radar equipment, drones and other military equipment.

ERNI USA manufacturing services provides 100% X-ray inspection when required and features an extra heavy-duty gantry inspection capability for handling populated double-sided PC boards that are up to 0.287 in. thick. ERNI’s testing capabilities go beyond automated optical inspection (AOI) and bed-of-nails testing. ERNI’s advanced Net-list testing coverage ensures 100% electrical testing of every connector contact point and every solder point via a RoBAT S1 backplane fixtureless test. With a rigorous quality control process and automated testing equipment, ERNI provides serialized data that is traceable at a cost far less than standard testing solutions.

ERNI test services can support any pitch, any connector and any size backplane. The automated equipment can also handle double-sided board testing. ERNI can process, produce and test with minimal NRE changes – all in less time and less cost.

“ERNI USA manufacturing provides the services military OEMs need to keep their development projects and special production runs on schedule,” said Allen Cowan, Systems Engineering Manager at ERNI USA. “With ERNI Manufacturing Services, there is no risk of a bad board reaching the customer’s end product. Our advanced testing capabilities and procedures ensure every military backplane meets customer specifications.”

ERNI Electronics
www.erni.com

Filed Under: EE sync, Industry News, Markets, Military, Products Tagged With: erni, ernielectronics

Reader Interactions

Leave a Reply Cancel reply

You must be logged in to post a comment.

Primary Sidebar

EE TRAINING CENTER CLASSROOMS

EE Classrooms

RSS Current EDABoard.com discussions

  • Feedback loop of TL431 based linear regulator?
  • timer event handling in C# scpi equipment communication
  • Op-amp simulation
  • UCC28070A PFC controller in DCM?
  • How to reduce the ring and spike on VDS of MOSFET

RSS Current Electro-Tech-Online.com Discussions

  • 2nd pcb design program?
  • My NE555 chips gone bad
  • Nokia 5110 HW in Oshonsoft
  • alternate of 80386/486 microprocessor
  • Drill speed controller fault
Subscribe today

Follow us on Twitter

Tweets by ConnectorTips

Footer

EE WORLD ONLINE NETWORK

  • EE World Online
  • EDA Board Forums
  • Electro Tech Online Forums
  • Analog IC Tips
  • DesignFast
  • Microcontroller Tips
  • Power Electronic Tips
  • Sensor Tips
  • Test and Measurement Tips
  • Wire and Cable Tips
  • 5G Technology World

Connector Tips

  • Subscribe to our newsletter
  • Advertise with us
  • Contact us
Follow us on TwitterAdd us on FacebookFollow us on YouTube Follow us on Instagram

Copyright © 2022 · WTWH Media LLC and its licensors. All rights reserved.
The material on this site may not be reproduced, distributed, transmitted, cached or otherwise used, except with the prior written permission of WTWH Media.

Privacy Policy