Connector Tips

Connector Tips has connector and electrical connector news, product highlights and and editorial coverage.

  • Industry News
  • Products
  • Connector basics
  • Blog
  • Markets
    • Aerospace
    • Automation
    • Electrical/Instrumentation
    • Medical
    • Military
    • Off-Highway
    • Oil/Gas
    • Telecom/Data
  • Suppliers
  • Newsletter Subscription
  • Video

Micro-Latch 2.00-mm wire-to-board connector system

September 6, 2019 By Mary Gannon Leave a Comment

Molex announces the Micro-Latch 2.00-mm wire-to-board connector system, ideal for customers in the industrial automation, consumer, and automotive markets. The connector system is designed for compact applications needing a high-temperature design that still meets all the standard requirements while offering superior reliability. Unique features enable the connector system to have better terminal retention, enhanced ruggedness, and exceptional mating capability.

Molex Micro-Latch 2-mm wire-to-board connector systemThe Micro-Latch 2.00-mm wire-to-board connector system offers 2 to 15 single-row plug-in circuits, with both vertical and horizontal configurations; through-hole terminals; a 2.00 mm-pitch low-profile connector; RoHS compliance and high-temperature capabilities; crimp terminals and cables widely available in the market; a fastener with terminal lance; a friction lock; and polarizing features — like the removal of one side housing wall — to help avoid mis-mating.

“Product reliability is the most important factor to determine the quality and superiority of a product/technology,” said Mariko Okamoto, global product manager, Molex. “Using Molex’s Micro-Latch connectors, customers can market reliability as the USP of their products.”

Compared to similar connector systems in the market right now, the Micro-Latch 2.00-mm wire-to-board connector system has a smaller depth and height, higher temperature-range durability, a higher voltage rating and smaller cables.

Molex
www.molex.com

Filed Under: DW sync, EE sync, Featured, Products, wire-to-board connector Tagged With: Molex

Leave a Reply Cancel reply

Your email address will not be published. Required fields are marked *

Connector Basics

DesignFast

Component Selection Made Simple.

Try it Today
design fast globle

EE Learning Center

“ee

RSS Current EDABoard.com discussions

  • TSMC65nm Bondpads and ESD.
  • Beginner question about a micro-controller project
  • Metastabilty and data loss
  • Connect MQ135 Gas Sensor to Raspberry Pi 3B+
  • Distance between MCU-Phy-Magnetics-RJ45

RSS Current Electro-Tech-Online.com Discussions

  • Esp8266 crashing after 30 mins
  • Counter 0 - 999 with flip flops
  • Long delay affected by low temperature?
  • possible 1N007 fault
  • Funny Images Thread!
Subscribe today

Follow us on Twitter

Tweets by ConnectorTips

EE WORLD ONLINE NETWORK

  • EE World Online
  • EDA Board Forums
  • Electro Tech Online Forums
  • Analog IC Tips
  • DesignFast
  • Microcontroller Tips
  • Power Electronic Tips
  • Sensor Tips
  • Test and Measurement Tips
  • Wire and Cable Tips

Connector Tips

  • Subscribe to our newsletter
  • Advertise with us
  • Contact us
Follow us on Twitter@ConnectorTips
Add us on FacebookEE World Online
Follow us on YouTube YouTube
Follow us on Instagram Instagram

Copyright © 2019 · WTWH Media LLC and its licensors. All rights reserved.
The material on this site may not be reproduced, distributed, transmitted, cached or otherwise used, except with the prior written permission of WTWH Media.

Privacy Policy