• Skip to primary navigation
  • Skip to main content
  • Skip to primary sidebar
  • Skip to footer

Connector Tips

Connector Tips has connector and electrical connector news, product highlights and and editorial coverage.

  • Industry News
  • Products
  • Basics
  • Electronics
    • Electronics
  • Markets
    • Aerospace
    • Automation
    • Electrical & Instrumentation
    • Medical
    • Military
    • Off-Highway
    • Oil/Gas
    • Telecom/Data
  • Suppliers
  • Newsletter Subscription
  • Video

NanoRF Edge launch connector eliminates cables

September 8, 2021 By Redding Traiger Leave a Comment

TE Connectivity has introduced the NanoRF Edge Launch connector, the only solution that can integrate the RF above an optical interconnect for military and radar RF embedded computing applications. The NanoRF connector meets the rigorous requirements of VITA 67.3 to provide a simple and standardized interface with VPX plug-in computing modules including RF switches, tuners, software-defined radios, and other embedded computing systems.

The NanoRF Edge Launch connector reduces space requirements, which eliminates the need for cables and results in a more rugged product. This smaller size comes without sacrificing performance, providing high density and high frequency up to 70Ghz. The NanoRF’s bullet adapter reduces tolerances and helps to allow for decreased mating force, which is required for stacked boards.

As a leader in designing VITA, VPX, and SOSA compliant solutions, TE’s NanoRF connector is configurable for different sizes and contact counts to ensure it supports VITA 67.3 interface for VPX industry-standard implementations or custom applications. This provides customers access to industry-standard products with VPX, SOSA compliance to support their plug-in computing modules.

You may also like:


  • How PCIe interface developments have changed and advanced
  • Close-up Dinkle terminal blocks
    Connectivity building blocks for motion control

  • How cable technology is evolving to meet high-performance networking
  • single-pair Ethernet
    Single-Pair Ethernet addresses industrial priorities, Part 2: Hardware realization
  • single-pair ethernet
    Single-Pair Ethernet addresses industrial priorities, Part 1: The IEEE 802.3cg…

Filed Under: connector components, DW sync, EE sync, ix connectors, Military, Products, RF Tagged With: teconnectivity

Reader Interactions

Leave a Reply Cancel reply

You must be logged in to post a comment.

Primary Sidebar

EE TRAINING CENTER CLASSROOMS

EE Classrooms

RSS Current EDABoard.com discussions

  • Feedback loop of TL431 based linear regulator?
  • timer event handling in C# scpi equipment communication
  • Op-amp simulation
  • UCC28070A PFC controller in DCM?
  • How to reduce the ring and spike on VDS of MOSFET

RSS Current Electro-Tech-Online.com Discussions

  • 2nd pcb design program?
  • My NE555 chips gone bad
  • Nokia 5110 HW in Oshonsoft
  • alternate of 80386/486 microprocessor
  • Drill speed controller fault
Subscribe today

Follow us on Twitter

Tweets by ConnectorTips

Footer

EE WORLD ONLINE NETWORK

  • EE World Online
  • EDA Board Forums
  • Electro Tech Online Forums
  • Analog IC Tips
  • DesignFast
  • Microcontroller Tips
  • Power Electronic Tips
  • Sensor Tips
  • Test and Measurement Tips
  • Wire and Cable Tips
  • 5G Technology World

Connector Tips

  • Subscribe to our newsletter
  • Advertise with us
  • Contact us
Follow us on TwitterAdd us on FacebookFollow us on YouTube Follow us on Instagram

Copyright © 2022 · WTWH Media LLC and its licensors. All rights reserved.
The material on this site may not be reproduced, distributed, transmitted, cached or otherwise used, except with the prior written permission of WTWH Media.

Privacy Policy